Hidden Power for your kitchen countertop - Flush Mount
The Hubbell RCT201BK is a flush-mount countertop pop-up power receptacle, that provides a reliable power source for kitchens, islands, and bathroom counters. This pop-up design is a part of the Hubbell power solutions that offer two 15A 125V tamper-resistant receptacles rated for 20A circuits. This unit features a compact design that eliminates reliance on wall sockets and saves under-cabinet space at the same time. There is no need to alter the cabinet spaces or remove the under-counter shelves to install Hubbell RCT201BK. The unit can be inserted in any convenient position on your countertop that improves the functionality of your space.
Providing elegance and style in a relatively small design is what makes these units truly stand out. As a flush mount pop-up unit, the Hubbell RCT201BK has a very low profile. The top is just a 3.5" round that completely lays flush with the surrounding surface when closed.
The Hubbell series of Pop-Up Outlets are extremely easy to use and operate. To open the device, press the top of the unit and it will pop out of the counter surface on its own. You will then have access to the two outlets for charging appliances such as phones, laptops, or tablets. The two 15-amp receptacles are at the opposite ends of the unit allowing for multiple devices to be plugged in without the wires being knotted.
The Hubbell RCT201BK is designed with modern living in mind. It is aesthetically pleasing, has space-saving functionality, and is easy to use. This all comes packaged as a stylish addition to any kitchen and is crucial to the success of any countertop.
Because sometimes spills happen!
One of the biggest accidents to occur in kitchens can be spills and splashes. Knowing that these accidents will occur, Hubbell has test and designed these pop up outlets to be water resistant to up to a half gallon spill! To make this happen these units features a unique silicone gasket that seals and protects the outlets and inner mechanics from water entering the device when in the open or closed position. To further protect the device, each 15A receptacle are water rater and tamper resistant to meet code.
Technical Jargon and Installation Steps
These units are UL498 Section 146 Listed which means they have been built and listed to be water resistant to a half gallon of liquid spilled on the device. In addition they meet NEC 406.5(E) code for Receptacle assemblies for installation in countertop surfaces are listed for countertop applications.
Installation is a breeze, with 8 simple steps (We do recommend the devices be installed by a licensed electrician)
1) Cut a circular hole approximately 3.5" in diameter in the countertop for surface mount installation. If installing a flush mounted trim, an additional counterbore cut is necessary: .09" deep with a 4" in diameter.
2) Remove the base from the housing to expose screw terminals.
CAUTION: Before handling the cable,
make sure the circuit is OFF.
3) Feed cable through the lock nut under the countertop, as this will secure the device later.
4) Fasten the metal jacket to the device base. A fitting will be required (not included).
5) Strip conductors to the correct length as shown on the device. Ground the base by bonding the green or bare wire to the grounding screw on the base. Terminate the green or bare wire to the green screw marked. Terminate the white or gray wire to the white screw marked “WHITE” and black or red wire to the brass screw marked “HOT”.
6)Reattach the base to the housing and secure with screws.
7) Insert the device into the countertop opening and hand tighten the lock nut to secure the device in place.
8) Terminate the device to the power source. Press the cover to pop up the receptacle to use, press again to close.